Cracked Lid

gordon stelter lclgcnp@yahoo.com
Sat, 30 Oct 2004 10:27:55 -0700 (PDT)


Evaporation of volatile components. Bacterial decay. (
See J.Garret's post about brittle action parts. )
Granted this would be less a factor in a veneered and
sealed component. But a definite  possibility, I
think.
    You have probably observed how  many open-faced
blocks are in better shape than their covered
counterparts? I think this has a lot to do with the
varnish on them. Perhaps we should varnish our new
blocks befor installing?
( If we believe in doing top-notch work, vs. planned
obsolescnce, that is, as do I! )
     Thump


--- Farrell <mfarrel2@tampabay.rr.com> wrote:

> How would it loose density/mass over time?
> 
> Terry Farrell
> 
> ----- Original Message ----- 
> From: "gordon stelter" <lclgcnp@yahoo.com>
> To: "Pianotech" <pianotech@ptg.org>
> Sent: Saturday, October 30, 2004 12:58 PM
> Subject: Re: Cracked Lid
> 
> 
> > Could the Oak or Ash also seem less dense just
> because
> > it was from well-aged large logs, sitting in a 
> piano
> > for 100 years?
> >      Thump
> > 
> > 
> > --- Farrell <mfarrel2@tampabay.rr.com> wrote:
> > 
> > > I don't remember chestnut very well from my wood
> > > technology class - I'm sure
> > > I had to memorize it's properties at some point.
> But
> > > I have cut up a number
> > > of vertical pianos and the core wood was not
> poplar.
> > > It looked a lot more
> > > like oak or ash, but clearly seemed less dense.
> Do
> > > you know offhand whether
> > > chestnut is less dense than oak and ash (both of
> > > which are darn dense!).
> > > 
> > > Terry Farrell
> > > 
> > > ----- Original Message ----- 
> > > From: "Ron Nossaman" <rnossaman@cox.net>
> > > To: "Pianotech" <pianotech@ptg.org>
> > > Sent: Saturday, October 30, 2004 12:46 PM
> > > Subject: RE: Cracked Lid
> > > 
> > > 
> > > >
> > > > >Good thoughts.
> > > > >I think the problem with this particular lid
> (the
> > > Steinway I've
> > > mentioned)
> > > > >is the lack of cross banding.  I' ve seen
> this
> > > omition before when I did
> > > a
> > > > >lot of furniture repair in another life. 
> Also,
> > > the oak core tends to
> > > move
> > > > >more, ends being the worst.
> > > > >
> > > > >Paul C
> > > > >
> > > > >    Paul
> > > > >   I agree about the cross banding thought.
> Stwys
> > > are poplar which is
> > > more
> > > > > stable than oak IMO.
> > > >
> > > >
> > > > Chestnut was a common furniture core wood too,
> and
> > > looks a lot like oak or
> > > > ash. It's more dimensionally stabile than
> either,
> > > which is why it was used
> > > > so much under veneers. For what it's worth.
> > > >
> > > > Ron N
> > > >
> > > >
> _______________________________________________
> > > > pianotech list info:
> > > https://www.moypiano.com/resources/#archives
> > > >
> > > 
> > > 
> > > _______________________________________________
> > > pianotech list info:
> > > https://www.moypiano.com/resources/#archives
> > > 
> > 
> > 
> > 
> > 
> > __________________________________
> > Do you Yahoo!?
> > Yahoo! Mail Address AutoComplete - You start. We
> finish.
> > http://promotions.yahoo.com/new_mail 
> > _______________________________________________
> > pianotech list info:
> https://www.moypiano.com/resources/#archives
> > 
> 
> _______________________________________________
> pianotech list info:
> https://www.moypiano.com/resources/#archives
> 



		
__________________________________
Do you Yahoo!?
Read only the mail you want - Yahoo! Mail SpamGuard.
http://promotions.yahoo.com/new_mail 

This PTG archive page provided courtesy of Moy Piano Service, LLC