This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment You did remember to put a 90 degree turn on the end, and insert it in the hole in the pin, didn't you? Remember and turn the pin out first, or you wont have enough room for the coils. John M. Ross Windsor, Nova Scotia, Canada jrpiano@win.eastlink.ca ----- Original Message ----- From: Jonathan Stuchell To: pianotech@ptg.org Sent: Thursday, September 09, 2004 10:22 PM Subject: Fw: installing new treble wire on a spinet ----- Original Message ----- From: Jonathan Stuchell To: pianotech@ptg.org Sent: Thursday, September 09, 2004 9:16 PM Subject: installing new treble wire on a spinet I am a novice and need advice on how to coil treble wire around the tuning pin. I am attempting to install a new treble wire on two pins. When I turn the pin clockwise with the tuning hammer the wire will not wind around to set the coils. Any help would be appreciated . Thank you. ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/e5/d8/bf/a1/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC