This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I experienced a new low today. I did a bunch of work on a 6' Hyundai = action (10 yo) and was set to do a bench regulation. Using my = pre-measured string heights, I found that I obviously made a gross = mistake with my measurement somehow. So I drove the 40 miles back to the = piano and re-measured - my original measurements were correct. The = hammers on this thing were bored to produce a full quarter-inch = overstrike. What are the correct words here - this is amazing - did they build all = their pianos this way? Don't they just have some jig in the factory = where all hammers for this model are drilled the same way? Did = somebody's finger get in there and jacked the jig up a quarter inch? Has anyone ever seen anything like this? Maybe I just haven't been = around long enough! Terry Farrell ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/d8/1f/98/3a/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC