Spinet horizontal side separation

[Terry]

No concern about poorly-mated glue surfaces (irregular chunks of old glue)
yielding a poor glue joint?

Terry Farrell

> >Yet, Terry, you are correct.  I attached a
> >back-of-the-envelope sketch to define "horizontal
> >side" and "vertical side".  What has come loose is the
> >upper "horizontal side, which really is also the
> >keybed support.  It is one slab, attached to the edge
> >of the back (presumably with glue) and to the lower
> >"vertical side" with two little angle brackets.
> >
> >Greg Graham
>
>
> I've done this a time or two, on site. A steel spatula, a bottle of
> Original Titebond, a few pipe clamps, some padding, a drop cloth, and a
> roll of paper towels. Apply all items as necessary, and come back tomorrow
> for your clamps and drop cloth.
>
> Just another day in the trenches.
>
> Ron N