Glue pinblock plugs

Gevaert Pierre pierre.gevaert@belgacom.net
Tue, 22 Feb 2005 23:26:04 +0100


This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
Hi,

Thanks for the input.
If I understand you fill the holes with epoxy completely to the top of =
the pin block? I suppose this is for making the new holes easyer to =
drill.
As it is an open face pinblock in this case I suppose it is easyer to =
fix than with a covered pinblock?

Pierre Gevaert
  ----- Original Message -----=20
  From: Carl Meyer=20
  To: Pianotech=20
  Sent: Monday, February 21, 2005 11:02 PM
  Subject: Re: Glue pinblock plugs


  I'd first seal the bottom of the block with wax paper, 1 inch foam and =
a particle board panel.  Use paste epoxy around the edges or it will =
leak.  Now warm the block (warm to the touch) to further encourage =
capillary action.  Fill all tuning pin holes with thin epoxy. Refill as =
needed. Epotek 301 is the thinnest I've found, but there are others.  =
Let cure for about 2 days and drill for plugs.  I'm not sure it matters =
much what glue you use for the plugs.  I've used titebond.  You may need =
to go to metric to get the best fit for the plugs, either 3/8 or 1/2.  =
Half inch may overlap making it a two step process.

  One time I drilled right thru the plate with a 3/8 drill and let the =
plugs be level with the top of the plate.  For cosmetics I used a =
bushing cloth punching over the tuning pin.  This piano already had the =
plate installed and I didn't want to take it out again.  I've done this =
a few times and haven't had any problems.

  Carl Meyer PTG assoc
  Santa Clara, Ca.

    ----- Original Message -----=20
    From: Gevaert Pierre=20
    To: Pianotech=20
    Sent: Monday, February 21, 2005 12:57 PM
    Subject: Glue pinblock plugs


    Hi list,

    I checked the Pianotech archives trying to find out what's the best =
way to glue laminated pinblock plugs in a cracked pinblock but I =
could'n't find out.
    Is epoxying  the best way to fix these plugs ore are there better =
glues?
    Thanks for some advice.

    Pierre
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/4d/7c/68/16/attachment.htm

---------------------- multipart/alternative attachment--



This PTG archive page provided courtesy of Moy Piano Service, LLC