This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Rick, For easing keys, I like to be just at or slightly below boiling. For setting, I flick a drop of water on the broach. If the water sits there, raise the temp. If it rapidly boils off, lower the temp. You just have to find the crossover point, and mark the dial. As a safety, I test it occasionally. Jerry Cohen, RPT NJ Chapter -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of richard.ucci@att.net Sent: Sunday, March 06, 2005 1:12 PM To: pianotech@ptg.org Subject: temp.setting Hi folks, Just ordered the temp.control unit for soldering iron tool used in key bushing easing etc. My question is, how to set the control so as to not melt aluminum pieces, and what is the best setting for key easing? Thanks, Rick Ucci/Ucci Piano ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/52/59/89/7d/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC