Hint: Once you have found where the screws in the key frame are located, take 30 seconds and mark the location, _with pencil_ on the key stick directly above the screw. If you make a circle and an x in the circle, the same size as the circle, it kind of looks like a Phillips head screw, and will be a clue to you next time how to find the screws much faster without a lot of searching. David Vanderhoofven At 12:17 PM 5/2/2005, you wrote: >Baldwin vertical rails are suspended by screws. >The holes in the rail at the B flats (usually) >are to access screw slots to raise the rail. > >Loosen the hold-down screws and turn the >support screw up or down and resecure the >hold-down screw. No shimming required. > >Regards, > >Jon Page
This PTG archive page provided courtesy of Moy Piano Service, LLC