Greetings,Arlie! Regarding Fallboard set screws:Apsco used to sell them separately,they were brass,special head,pointed end,size 6/32",standart thread.they were made by Ramsey Corporation for all Piano Manufacturers. I happened to have the whole collection,plus all taps to restore or enlarge hinge threads. A small clear plastic box with all sizes screws,,corresponding taps is very useful to me when working in schools. If you can buy appropriate screws in hardware store-make sure it's not too long and not leave a gauge in the cheeck block..If you will have a problem finding the right screw-call me,I will send you a replacement. Good luck! Isaac -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Arlie Rauch Sent: Tuesday, May 17, 2005 8:35 PM To: pianotech@ptg.org Subject: Fallboard screw A customer has a Fischer grand which had a little screw at each end of the fallboard. These screws must be removed in order to remove the fall board. One of the screws is missing, and I don't see any like it in the Schaff catalog. Any suggestions? Thanks. Arlie Rauch Glendive, MT _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC