Warped Plate on Henry F. Miller

[Farrell]

Greg - Yes, Joe means the action rail (hammer flange rail). By remounting, 
if not straight, he means to either shim or remove wood from the action 
frame so the brackets support the rail in a straight line.

Terry Farrell

----- Original Message ----- 
From: "Greg Newell"

>         By "rails" I assume you mean action or key frame rails. I have not 
> checked that. I'm not sure what you mean by remounting them. I think they 
> sit flat on the keyframe.
>
> regards,
> Greg
>
>
>
> At 01:08 AM 9/19/2005, you wrote:
>>Greg Newell said: "Any other thoughts?"
>>
>>Greg,
>>Have you checked the rails, to see if they are, (also), warped? If the 
>>"scraping" is only happening in the middle, you do have some wiggle room, 
>>if you remount the center action brackets.
>>Regards,
>>
>>Joe Garrett, R.P.T.