This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Joe, Probibly off the wall, but could it be that the plate to pinblock screws = arenot tight? Allowing the screw to actually push the block down in the = middle. The plate holes would have to be too small for this to happen. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Joe Garrett=20 To: pianotech=20 Sent: Sunday, September 18, 2005 11:08 PM Subject: Re: Warped Plate on Henry F. Miller Greg Newell said: "Any other thoughts?" Greg,=20 Have you checked the rails, to see if they are, (also), warped? If the = "scraping" is only happening in the middle, you do have some wiggle = room, if you remount the center action brackets. Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/2a/e5/ec/16/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC