Thanks Paul, You are correct in the way they were manufactured Thanks Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Paul Chick (Earthlink)" <tune4@earthlink.net> To: "'An open list for piano technicians'" <pianotech@ptg.org> Sent: Thursday, January 12, 2006 9:00 AM Subject: RE: threadbear > > Subject: threadbear > > Hi, does any one know the thread size on the wire stickers of a Kimbal > drop-action? > I do not have easy access to the instrument and know the rubber has bonded > to the wire, and will make installing the new nuts real hard. Removal of the > action is not an option, or I would use my mini torch to burn off the old > rubber. Size of rod and TPI > HELP! > Joe Goss RPT > > If memory serves me right, the threads on the rods are rolled, not cut with > a die. Rolled threads will be larger in diameter then the rod, but the right > size for the nut. Running a die over them will decrease their diameter. The > nut will be quite loose. Test very carefully. > > Paul C > > _______________________________________________ > Pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC