Sorry, just saw the source question. I get mine from McMaster Carr http://www.mcmaster.com/ Terry Farrell > At 06:42 PM 1/30/2006 -0600, you wrote: > I'm finally getting around to working on the piano which had a boomy > crossover from the long bridge to the bass bridge. I'm envisioning > getting some rolled brass stock and cutting off pieces for this. I've cut > aluminum with a carbide blade, I think brass might be a little harder. > How difficult is this to do? I'd drill a screw hole in the center and > temporarily set under the bridge until I get the impedance I want. > >>How do you pro's do this? Where do you source your material and what is >>your favorite means of machining it? >> >>Andrew Anderson
This PTG archive page provided courtesy of Moy Piano Service, LLC