I don't find there to be any reason to remove the action for a tenor string replacement. Sure, it would be easier, but I don't think the small advantage is worth it. YMMV Terry Farrell ----- Original Message ----- Always good to make Dad feel useful...;-] There is a stringing tool, which is basically a tube you slide the crimped string into. I've heard a curtain rod also works. Of course your removing the action...a long piece of brass rod with a notch in the end...once the string is in place use a clamp of some sort to hold it onto the hitchpin...vice grip works. If nothing else the crimped wire will slide under the strings with a little *&^#%@. You have to hold tension on the wires so they don't want to slide between strings... David Ilvedson, RPT Pacifica, California ------------------------------------------------------------------------------ Original message Hi everyone. I was tuning my mom's ancient upright (1908) and of course a string broke. Even worse, it was D#4 and in the area where the strings overlap. While this was great stringing practice, I have to believe there's a trick to getting the string where it needs to go (and stay there) without hours of heartache and assistance from my dad! I felt like I was torturing this poor old piano. Any words of wisdom? Michelle Smith Bastrop, Texas -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060710/9719cc16/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC