Brass but plates

[Thomas Cole]

Julia,

One word of caution: if you have a double flange (hammers and dampers) 
you're out of luck as far as having Schaff doing the duplication. They 
only do the type which have the fingers on one side of the brass plate. 
Found that one out the hard way.

Tom Cole
Santa Cruz, CA

KeyKat88 at aol.com wrote:

> Greetings,
>  
>             On an old upright, instead of flanges on the ends of the 
> hammer butts there is a brass plate system of attatchment to the 
> action rail. If the corners of the brass plate in the paino are broken 
> off, can one replace the entire brass butt plate? In a shop, Are they 
> easy to remake?How many hours would this job take?
>  
>  
> Julia Gottshall
> Reasding, PA

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060714/c95f720d/attachment.html