Where do I find spurlock articles?

[Farrell]

Where do I find them?

Thanks,
Julia Gottshall
REading, PA
  ----- Original Message ----- 
  From: Farrell 
  To: Pianotech List 
  Sent: Friday, July 21, 2006 12:04 PM
  Subject: Re: Longer dampers than original


  It is a good idea "to replace dampers on an old upright with ones that are longer". I highly recommend getting a copy of Bill Spurlock's paper on Vertical Damper Replacement http://www.spurlocktools.com/id36.htm .  Piano Forte Supply has 55 mm and 67 mm long upright bass dampers:  http://www.pianofortesupply.com/dampers1.html

  Yes, you could measure the spring tension with a spring gauge, but any old upright is likely to have very weak wires. Consider replacement - and it is often easier to replace the entire damper lever assembly.

  I guarantee you, you don't want to mess with upright dampers without Bill Spurlock's paper in front of you. Only $2.50 and worth hundreds easily.

  Terry Farrell
    ----- Original Message ----- 

              Is it a bad idea to replace dampers on an old upright with ones that are longer, we're talking about 3/8" longer (3/16ths at each end). ...and this would be for the bass's bi and mono dampers only. Is the longer length going to cause a problem when the damper goes to lift? 

    Also, while I am in there, is it a good idea to verrrry slightly (bend) each damper's spring wire so that it strengthens their pressure on the strings? Is there a way, perhaps a gage, to measure the pressure of these springs? If it can be measured, what should it be?

    Thanks
    Julia Gottshall,
    Reading, PA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060723/48106543/attachment.html