In a message dated 7/29/2006 2:30:24 PM Central Daylight Time, debrafeiger at gmail.com writes: > Can someone tell me the tool(s) they use to remove key leads? Thank you > A simple punch close to the diameter of the lead is good; too small will spread the lead and tighten it in the hole. Support the key around the diameter of the hole with a simple jig (a block with hole drilled in it to allow the key lead to fall through). I have found some instances where the key lead is so tight that I felt that I might split the key; I have drilled a hole offset from the center of the lead and then used a small diameter punch to spread the lead away from the wood surface of the key. The lead can then easily be pushed out. PR-J -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060729/2fe3f557/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC