william ballard wrote: > On Jul 30, 2006, at 10:24 AM, Roy Peters wrote: > >> The coredrill is 37/64". I didn't notice this difference before I >> ordered. So, I have just punched them out the way others here have >> described. This works well enough for now. I'll upgrade my drill >> press at some point. > > > Or have a local machinist turn the shank down to 1/2" for you. > > Mr. Bill I just received one of those from Pianotek. The shank diameter is .500", but it looks like someone held it out the door of a speeding car and ground it on the curb. He sure had a good eye for .500" though. Tom Cole
This PTG archive page provided courtesy of Moy Piano Service, LLC