With the tension on can you tap it back into place and will it stay? If not, then the angle of that part of the plate isn't right to hold it in place with just string pressure. When installing an entire length in such situations I usually pin it. However for your testing purpose you won't want to do that. Does it tend to slip toward the tuning pins or away from them? If it's toward the tuning pins you might cut a short, thin strip of wood that you can place between the new brass half round and the old counterbearing bar to hold it in place. If it's slipping away from the tuning pins.I'll have to think about that one. David Love davidlovepianos at comcast.net -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Jeannie Grassi Sent: Thursday, March 09, 2006 7:53 PM To: 'Pianotech List' Subject: RE: v-bar/capo repair I had a problem keep a length of brass half round in place. I'm interested in knowing what people use to make sure it doesn't move. It was a longer piece that extended the entire treble area. It was a slippery little thing that moved when the tension was brought up to pitch. jeannie Jeannie Grassi, RPT Registered Piano Technician Island Piano Service Bainbridge Island, WA 206-842-3721 <mailto:jcgrassi at earthlink.net> mailto:jcgrassi at earthlink.net _____ From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Barbara Richmond Sent: Thursday, March 09, 2006 1:40 PM To: Pianotech List Subject: Re: v-bar/capo repair Hi David, When experimenting duplex length with brass half or oval round, would you, in this case, place anything on the bottom of the brass to avoid scratching the plate? Or isn't it a problem? Thanks, Barbara Richmond ----- Original Message ----- From: David Love <mailto:davidlovepianos at comcast.net> To: 'Pianotech List' <mailto:pianotech at ptg.org> Sent: Tuesday, February 28, 2006 10:25 PM Subject: RE: v-bar/capo repair Like Ron N. says, I think it's likely it has to do with the front duplex and you may be able to shorten, detune and increase the deflection angle by inserting some brass of appropriate dimension-at least you can experiment. If it turns out that that's the problem, it's not that big a deal to remove the strings from one section and insert the new counterbearing piece and then replace the strings (the same ones you took off). Unhook them from the tuning pins slip in the brass or whatever and then reattach-if that proves to be the problem. I get brass of varying sizes from www.rjleahy.com <http://www.rjleahy.com/> . They will cut to a reasonable shipping size. I don't know the configuration of this piano but maybe you can send pictures and some suggestions could be made by various people, I'm sure. If the noise disappeared originally by muting the front duplex, it is likely that there is leakage occurring and that's what you should address. Shortening the section and increasing the deflection can do that. You do want to be sure that the angle and deflection work together. The longer the duplex the greater the deflection angle. Similarly, a shorter duplex requires smaller angle. David Love davidlovepianos at comcast.net -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060309/89fb40f8/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC