Snipe would be a concern as one of the things I will use this for is planing out those little cutouts from Steinway long bridges. Similarly, I will be running the topside through the planer as well. What is the best way to avoid snipe when pushing something like that through? David Love davidlovepianos at comcast.net -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Lhadeh at wmconnect.com Sent: Thursday, March 23, 2006 6:52 PM To: pianotech at ptg.org Subject: planers I have an old Ryobi that I bought from a woodworking neighbor a couple of years ago. I remember giving him about $75 for the planer with 3 extra blade sets recently professionally sharpened. He upgraded to a DeWalt because it causes less snipe at the ends of the planed boards. Snipe is a problem with most planers. There are several ways to make it less of a problem, but none that I know of that will completely eliminate it. I either waste the 3 inches at each end of the board that has the snipe, or I can almost eliminate it by feeding short sacrificial boards in ahead and behind the good board. Several of the woodworking magazines have had extensive reviews in the last year or so. One likes Makita, another DeWalt, another Delta, another Ridgid, etc. I wouldn't think you'd go wrong with any of those. -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060325/b1ba9b7d/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC