I'm not sure what you mean? The discussion has been about rib crowned and supported assemblies. The panel has nothing to do with the calculations on load support. David Love davidlovepianos at comcast.net -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ric Brekne Sent: Tuesday, March 28, 2006 1:26 PM To: pianotech at ptg.org Subject: laminated ribs Dont mean to butt in on a nice discussion I've been following.. but I have a question thats been bothering me ever since the Bluthner discussion was up a bit back.. If you have soundboard grain alligned roughly perpendicular to the bridge... and assuming for the moment that you are able to create with this allignment enough load support for a low tension / low load scale.... what are the real demands for cross grain load support ? And is this (can it be ?) independant from the need for cross grain stiffness? Thanks RicB
This PTG archive page provided courtesy of Moy Piano Service, LLC