Hey Joe When you say forward edge, do you mean towards the player or towards the tail? Dean Dean May cell 812.239.3359 PianoRebuilders.com 812.235.5272 Terre Haute IN 47802 -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Joseph Garrett Sent: Sunday, May 07, 2006 12:42 PM To: pianotech Subject: Brambach Regulation Andrew said: "You want the back edge of the jack to line up with the back edge of the spline in the knuckle and to rapidly reset under the knuckle each cycle..." This is totally incorrect! The forward edge of the wood moulding of the "knuckle" should be in line with the CENTER of the jack! Also, a blow distance of 1 3/4" is advised. A 3/8" dip is good place to start, but after-touch will dictate where it should be. Just so's ya know. Regards, Joe Garrett, R.P.T. (Oregon) Captain, Tool Police Squares R I -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060507/fedc7af1/attachment-0001.html
This PTG archive page provided courtesy of Moy Piano Service, LLC