Bob, I'm not an expert, but I'd say if there is room (and I suspect there is) just drill out the plate to enlarge the existing tuning pin holes in the plate to whatever size bushing you wish to use. Regards, William R. Monroe > On a grand I'm rebuilding the old tuning pin bushings > were .41 od but I am unable to find a new set that is > anything smaller than about .44 od. > > Would you just not put in bushings on this one, or do > you have a quick method of reducing the size of the > bigger bushings? > Bob Hull
This PTG archive page provided courtesy of Moy Piano Service, LLC