Steinway will provide a bore spec sheet for each model but it's largely irrelevant since string heights vary not only within each model but within each individual piano. As JD suggests, to be really accurate you have to measure each piano and each section. David Love davidlovepianos at comcast.net www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of KeyKat88 at aol.com Sent: Tuesday, October 10, 2006 4:44 AM To: pianotech at ptg.org Subject: for Jon: Does S&S provide spec sheets? In a message dated 10/9/2006 2:32:09 PM Eastern Standard Time, jonpage at comcast.net writes: Hammer flange center to bottom of string: S-B C-D 4.6 cm 4.9 cm Whippen flange center from strings: 11 cm 11.3 cm Notice the difference in height of the rails' center pins. Something to keep in mind. -- Regards, Jon Page Greetings, Following this interesting post I ask, does S&S provide spec sheets? Just curious. Thanks Julia Gottshall Reading, PA -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20061010/223d287a/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC