removing shanks from butts

[Barbara Richmond]

Do you have a heat gun?  Perhaps heating the parts (without scorching) would 
help.

Barbara Richmond, RPT

----- Original Message ----- 
From: "ed miller" <edmiller3 at hotmail.com>
To: <pianotech at ptg.org>
Sent: Saturday, October 21, 2006 9:42 AM
Subject: removing shanks from butts


> List,
>
> I am about to rebuild a set of hammer butts, and put in new shanks and
> hammers. However, I can't get these pesky shanks out of the butts. I have
> done everything I've learned..... breaking away the collar, soaking the
> shank/butt joint with wallpaper remover, even applying some steam to help
> loosen the glue (it is hot hide glue).
>
> I've only tried it on shanks that have hammers already broken off. So I've
> been using a shank clamp as the end point for the shank/butt remover to
> push against. The clamp keeps sliding up the shank before the shank/butt
> joint will break loose (and I've tightened it really hard, to the point
> where the shank is pretty smooshed).
>
> Does anyone have any suggestions?
>
> Thanks,
> Ed
>
> _________________________________________________________________
> Stay in touch with old friends and meet new ones with Windows Live Spaces
> http://clk.atdmt.com/MSN/go/msnnkwsp0070000001msn/direct/01/?href=http://spaces.live.com/spacesapi.aspx?wx_action=create&wx_url=/friends.aspx&mkt=en-us
>