> 1. How do bend your half rounds to conform to any required sweep? > Clamp in a form? As it happens, I made a set just now. Here are some appropriately low res photos. Off to drill the block and start stringing. Ron N -------------- next part -------------- A non-text attachment was scrubbed... Name: rough bearing bar.jpg Type: image/jpeg Size: 48563 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070808/7b515984/attachment-0003.jpg -------------- next part -------------- A non-text attachment was scrubbed... Name: finished bearing bar.jpg Type: image/jpeg Size: 51553 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070808/7b515984/attachment-0004.jpg -------------- next part -------------- A non-text attachment was scrubbed... Name: bar bender.jpg Type: image/jpeg Size: 44117 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070808/7b515984/attachment-0005.jpg
This PTG archive page provided courtesy of Moy Piano Service, LLC