> ASAP. But imagine a half-round going sideways across > the top of the string, at 90 degrees to the string's > length. That, I believe, should be the contact point > for the string whose bearing is being measured, and > would make it far, far easier to align the stationary > feet on the speaking and waste ends of the string, > without the measuring contact slipping off the side of > the string ( as it does very readily with the ball > bearing tip ). I don't know if a tip like that is in > the 22 pice set I ordered, but for $12.00 ( including > shipping ) I figured it was worth a look-see. > ( Or there might be one I could modify. ) > Thump Touching the ball tip to the wheel of a bench grinder will make it flat enough in seconds. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC