Has anyone modified Bill Spurlock's tapering jig for use with the shanks attached? Would someone kindly post a picture or photo of a hammer tapering jig for the tablesaw that will allow one to taper hammers with the shanks attached? I have an idea for my own jig when used with a tilting table saw and setting the taper angle using a digital angle finder or combination square, but why reinvent the wheel if there is something already available? I'm also wondering if tapering could be done on a scroll saw without making a mess of the hammers (too fine of a blade). Regards... Greg --------------------------------- TV dinner still cooling? Check out "Tonight's Picks" on Yahoo! TV. -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070708/2c309f81/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC