Hammer tapering jig

[Joe And Penny Goss]

Hi Greg,
Roger Jolly developed a jig prior to Bill's.
Might ask him. Used a table saw I think.
Joe Goss RPT
Mother Goose Tools
imatunr at srvinet.com
www.mothergoosetools.com
  ----- Original Message ----- 
  From: Greg W. 
  To: PTG list 
  Sent: Sunday, July 08, 2007 3:20 PM
  Subject: Hammer tapering jig


  Has anyone modified Bill Spurlock's tapering jig for use with the shanks attached?

  Would someone kindly post a picture or photo of a hammer tapering jig for the tablesaw that will allow one to taper hammers with the shanks attached?

  I have an idea for my own jig when used with a tilting table saw and setting the taper angle using a digital angle finder or combination square, but why reinvent the wheel if there is something already available?

  I'm also wondering if tapering could be done on a scroll saw without making a mess of the hammers (too fine of a blade).

  Regards...

  Greg




------------------------------------------------------------------------------
  TV dinner still cooling?
  Check out "Tonight's Picks" on Yahoo! TV.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070708/987d0fb6/attachment.html