Jon, I saw your jig referenced several times in the research I did through the archives. I'm sure it works as advertised for you but I just didn't feel good about my abilities to use it with what I consider the proper amount of control. My shortcoming I'm sure. Thanks anyway! Greg Newell Greg's Piano Forté www.gregspianoforte.com 216-226-3791 (office) 216-470-8634 (mobile) -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Jon Page Sent: Monday, August 25, 2008 10:23 AM To: pianotech at ptg.org Subject: [CAUT] hammer thickness trimming jig Trim on a table saw with a jig like this: -- Regards, Jon Page
This PTG archive page provided courtesy of Moy Piano Service, LLC