[CAUT] hammer thickness trimming jig

[David Love]

Table saws and routers always make me a bit nervous especially when trying
to support the object in question with hand held pressure.  It seems like
one could construct a jig where the hammer is held strike point down so that
the shank doesn't actually get in the way and you could create some kind of
holding mechanism so fingers or finger pressure to hold things in place
would not need to be used.  The width of the hammer could thus be thinned
and weight removed to the point just before where the shank engages.  A belt
sander could then be used to clean up the area around the shank were it
necessary.  I'll have to give it some thought when the shop empties of
pianos (which isn't likely any time soon).  It might be easier just to
remove the offending set from the shanks, thin them on the Spurlock jig and
rehang them.  The customer is paying, after all.  Why put your fingers at
risk to save them a few bucks.  

 

David Love
davidlovepianos at comcast.net
www.davidlovepianos.com 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080825/0c2c338f/attachment.html