Do you just put the epoxy along the flange edge of the block? Do you use a mold release or soap on the plate? I see one advantage in that any squeeze out goes down (paper on the keybed). Ed > > Just that. The block is fitted and temporarily screwed to the plate with > four or five screws, located and glued in the piano, and the plate is > pulled for doweling the block ends. When I put the plate in for the FINAL > time, I glass the block, install the plate, and all of the screws. I don't > separate the plate from the block after glassing. The plate only goes out > and back of the piano twice total, if I sequence things right. Out at tear > down, in to locate the block and bridges, out for doweling the block and > installing the board, and in with epoxy to finish. > > Ron N > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC