erwinspiano at aol.com wrote: > Nicely done...What are you using for casptans. Source? > Dale These are recessed head 10-24 hex head machine screws with the tops cut down on a lathe. Where I got them is bookmarked - somewhere, but it's eluding me at the moment. They were what I could find at the time that met what I thought were my requirements. #10 is overkill, but I wanted 24tpi instead of the 32 I'd get with #8 or #6. Brass would be nice, or stainless, but I didn't find anything I liked. Wood screw threads would be fine too, like those on Jurgen's capstans. There's probably something out there that's just the thing, if it would only turn up. All suggestions from any source would be appreciated. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC