Al, There is a flat-topped slotted screw under the plate at the rear, or should be! The accu-just Baldwin grands that I have re-strung have this set screw in the rear, under the plate. Regards, Rob K On 13 Feb 2008 at 18:07, AlliedPianoCraft wrote: > > Rob, I have the pinblock height set exactly as it was from the factory. Left - Right, Up - Down. All > shims in place. The front of the plate is correctly set as it was. Is the adjustment screw at the tail > visible/adjustable from the top or do I need to remove the plate to adjust it? I didn't notice it when I > had the plate upside down fitting the pinblock. > > Al Guecia
This PTG archive page provided courtesy of Moy Piano Service, LLC