On Thu, Jan 15, 2009 at 1:20 PM, J Patrick Draine <jpdraine at gmail.com>wrote: > Have you looked in the Pianotek Supply catalog? On page D-13 there's the > Double Drop Screwdriver (JDD-3), as well as the Grand Drop Screwdriver > (JDS-2), the Upright Jack Screwdriver (JJS-1). I *think* the JJS-1 works > great with grand jacks -- I suggest you send an email or make a phone call > to verify that. I believe the shaft of the JDD-3 is thicker than the other > two, but it is an excellent tool. Maybe Jurgen G or Joe G has something with > an even thinner shaft. Patrick Draine > I have the double drop screwdriver from Pianotek. After the initial perturbation that it wouldn't fit between letoff dowels on all pianos, I ground it down with a bench grinder. It's not as pretty, but it's small enough now, and works just fine. -- JF -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090115/2ff8fe61/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC