[pianotech] New Asian piano that will not hold a tuning

wimblees at aol.com wimblees at aol.com
Sun Jun 14 20:01:35 MDT 2009


All of what you recommend, Larry, are very legitimate. But who's going to pay to do it? The customer shouldn't have to pay for this. The store should, but won't until they give the approval to do it. Since David has already told the store about the problem, the ball is in their court. 


Wim

-----Original Message-----
From: Larry Fisher RPT <larryf at pacifier.com>
To: pianotech at ptg.org
Sent: Sun, Jun 14, 2009 3:19 pm
Subject: [pianotech] New Asian piano that will not hold a tuning




A piano that keeps slipping that much over that much time has something major loose somewhere.? Even a loosely strung tuning pin doesn't slip that much.? Still, it's possible that the piano didn't have much of a tuning history prior to it's departure from the factory.? I'd check for movement? ........?? the plate will lift if it's not secured well so check all the perimeter bolts and make sure there?aren't maybe a few that are stripped out? .......?? rare but possible.? Look for lifting or plate distortion all the way around the rim.? The nose bolts should be tight and check for a crack in the plate at those points? .........? the plate failures I've seen have all happened around the area where the struts meet the tuning pin webbing area.? 

?

Check where the pin block meets the cabinet? ........? from inside the action cavity look up at the junction? .........? ?bass and treble.? There shouldn't be a gap there.? If the plate is distorting due to lack of anchoring, downbearing will be affected.? A simple sewing thread stretched across the bridge, duplicating the path of the string will show if you have positive or negative downbearing.? 

?

Check the crown of the soundboard.? I don't expect a soundboard has enough crown in it to cause a piano to drop 100 cents, especially in the treble?but it's easy enough to check? .............?? a thread once again strectched between the ribs tells all.

?

The shim in the horn.? Make sure it's still there.? If there's a adjustment bolt, make sure it's tight.

?

Just some ideas to check that are easily enough done.

?

Lar

?

?

?

?

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20090614/578ff63c/attachment.htm>


More information about the pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC