Then I would have to re-pin all of the stickers too. I would rather not. It all came out okay. Now the fun part begins. Putting it back into the piano, hooking it up again to the keys and regulating it. yippee, I can hardly wait. ;-) From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of wimblees at aol.com Sent: Tuesday, June 16, 2009 12:17 AM To: pianotech at ptg.org Subject: Re: [pianotech] Kimball Whitney Spinet Jerry Would it be easier to replace all the stickers, along with the grommets? Wim -----Original Message----- From: Gerald Groot <tunerboy3 at comcast.net> To: pianotech at ptg.org Sent: Mon, Jun 15, 2009 5:18 pm Subject: [pianotech] Kimball Whitney Spinet Our favorite piano... But, a very good customer. I've been tuning this piano like clockwork every year for the past 25 years or more during the last week in January. Very well taken care of except for the fact that the rubber grommets were getting very noisy and brittle. Today, I took the action to my shop. Remember how they put in those screws? Those 20 foot long screws? RAM them in without pre-drilling or proper sized drilling? What a miserable thing to take apart! Even the fall board screws were jammed in. I had all I could do to get them out without stripping the slot in the flat head screws. Then, I had to literally jam the grommets off from the keys as carefully as possible with a screwdriver. No way could I pull them off they were like, frozen in place. It was then, that I discovered sometime in the past year or two, I hadn't noticed it before, there was mice piss all over the place. On the stickers, the threads, the grommets, prongs on the ends of the keys etc. What a fricken mess. Talk about RUST??? It's all over those parts. Now, I am deciding on the best course of action to remove the rust. I'm thinking, either good old fashioned steel wool or a drill with a wire brush perhaps? However, I do not want to ruin the threads either. Someone mentioned using "Never Dull" but, I've not tried it on rust before. Works great on brass or balance rail pins.. Anyway, I will be working on this action tomorrow in the shop. Any bright ideas out there for removing this rust easily besides good old fashioned elbow grease? Thanks, Jer Jerry.5 _____ <http://www.avast.com/> avast! Antivirus: Outbound message clean. Virus Database (VPS): 090615-0, 06/15/2009 Tested on: 6/15/2009 11:18:13 PM avast! - copyright (c) 1988-2009 ALWIL Software. _____ Make your summer sizzle with <http://food.aol.com/grilling?ncid=emlcntusfood00000003> fast and easy recipes for the grill. _____ avast! Antivirus <http://www.avast.com> : Outbound message clean. Virus Database (VPS): 090616-0, 06/16/2009 Tested on: 6/16/2009 4:12:53 PM avast! - copyright (c) 1988-2009 ALWIL Software. -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20090616/197c5038/attachment-0001.htm> -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 14480 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20090616/197c5038/attachment-0001.jpeg>
This PTG archive page provided courtesy of Moy Piano Service, LLC