David Love wrote: > I’m curious how those of you who do radial ribs arrays deal with the > fact that in such a pattern the ribs will be closer together on the bent > side of the case creating somewhat of a differential in stiffness from > one side of the board to the other. Do you do anything to compensate > for that? I can see a couple of approaches if it mattered: First, stop > every other rib somewhat short of the rim on that side; second, taper > the ribs slightly narrower moving toward the bent side. Third, ignore > it and go to the next problem. I mostly ignore it. I figure the center of support is mostly along the bridge line, which is mostly centered on the ribs, and the stiffness at the point I think it most matters is still (mostly) controllable. Relatively speaking, Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC