If I was moving grand pianos again, I would definitely be using the horse thingy David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: PAULREVENKOJONES at aol.com To: pianotech at ptg.org Received: 11/23/2009 3:56:12 PM Subject: Re: [pianotech] Lyre Damage >I guess my question is: why use the pedal lyre at all as a pivot point, >braced or not. It is no faster than to take off the lyre which needs to be >done anyway, remove the bass leg and lower the bass corner to a skid, then >roll the piano up and take off the other legs. > >The pedal lyre is not designed for the stress of using it as a pivot. Good >moving practices don't need it. > >P > > >In a message dated 11/23/2009 8:36:39 P.M. Central Standard Time, >anrebe at gmail.com writes: >I always use a lyre brace since a brand new chinese one broke its lyre >when I was tipping. No problems since. >You can by one from QRS or you can make your own. >length of steel electrical conduit >length of all-thread that just fits inside >a matching nut and washer >a length of 2x2 >self adhesive felt lamp bottom covers >some type of flexible adhesive like PL400 >cut the 2x2 into two reasonable lengths and drill one corner to accept >conduit/all-thread and adhesive >apply the self adhesive felt to the business sides of the 2x2s and you >have an adjustable brace. >Andrew Anderson >On Nov 23, 2009, at 5:42 PM, _JWyatt1492 at aol.com_ >(mailto:JWyatt1492 at aol.com) wrote: >Hello Garrett, > > I never tip a Oriental Grand Piano on the Lyre. >I tip all American Pianos except one, that being >the H.C.Bay. > > Weak wood is always weak wood. >I have repaired too many pedal Lyres. > > >Regards >Jack Wyatt >=
This PTG archive page provided courtesy of Moy Piano Service, LLC