Woah....woah....Terry, that will null and void your warranty... David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: "Terry Farrell" <mfarrel2 at tampabay.rr.com> To: pianotech at ptg.org Received: 9/3/2009 6:00:08 AM Subject: Re: [pianotech] Tuning wrench tip threads? >That's what I was going to say. I wanted to shorten the shaft length >of my Keith Bowman tuning lever, but that of course required new >threads. I found a small local machine shop that did an A-1 job for me. >Terry Farrell >On Sep 3, 2009, at 2:13 AM, James Johnson wrote: >> A good machinist should be able to guage the tread size and make >> whatever you need, probably better quality than you could do yourself. >> >> ----- Original Message ----- From: "Jack Reisland" <reislandj001 at hawaii.rr.com >> > >> To: <pianotech at ptg.org> >> Sent: Wednesday, September 02, 2009 8:39 PM >> Subject: [pianotech] Tuning wrench tip threads? >> >> >>> Does anyone know what size/ pitch the threads are in a standard >>> tuning wrench tip? I am playing with making a wrench, and need to >>> match it. >>> >>> Best Regards, Jack Reisland >>> >>> >>> >>> >>
This PTG archive page provided courtesy of Moy Piano Service, LLC