I am glad you told me about the heat weakening the epoxy, I hadn't heard that before. In fact I have never heated it in the past, but thought I had seen that recommended on the list in the past. John Ross Windsor, Nova Scotia. On 29-11-2011, at 8:41 PM, Rob McCall wrote: > Am I to assume we're talking about added heat over and above what the epoxy produces all on it's own? > > I like the West system. It doesn't get any easier than that for me. :-) > > Regards, > > Rob McCall > > McCall Piano Service, LLC > www.mccallpiano.com > Murrieta, CA > 951-698-1875 > > On Nov 29, 2011, at 11:16 , Delwin D Fandrich wrote: > >> Heat will also weaken epoxy. Use a thin coating epoxy such as that made by System Three. >> >> ddf >> >> Delwin D Fandrich >> Piano Design & Fabrication >> 6939 Foothill Court SW, Olympia, Washington 98512 USA >> Phone 360.515.0119 — Cell 360.388.6525 >> del at fandrichpiano.com — ddfandrich at gmail.com >> >> From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of John Ross >> Sent: Tuesday, November 29, 2011 8:20 AM >> To: pianotech at ptg.org >> Subject: Re: [pianotech] Bridge cap epoxy >> >> Heat will thin epoxy, so that it penetrates. >> John Ross >> Windsor, Nova Scotia >> On 29-11-2011, at 5:49 AM, Joe Wiencek wrote: >> >> >> Hello list, >> I've been reading with great interest about the recent articles in the Journal about treating bridges with thin epoxy. I am trying to imagine an epoxy that's thin enough to be put on the bridge cap without it adding material. Is there a very thin viscosity epoxy on the market that's being used for this, or the possibility of thinning epoxy with lacquer thinner or some other solvent? >> Thanks for any input. >> >> Joe Wiencek >> > -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20111129/2244652b/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC