Who makes it, and where did you buy that special tape to hold it on your jig? Thanks, Ron Will -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Friday, September 30, 2011 3:57 PM To: pianotech at ptg.org Subject: Re: [pianotech] bridge pin drill speeds On 9/30/2011 12:33 PM, Encore Pianos wrote: > To those of you on the forum who do bridge recapping and such, I pose > the following question: what do you consider to be an optimal RPM > speed for the bridge pin drill bit to be turning at? Beats me. I built this little bridge drill with the B&D motor because it had the highest rated amperage I could find. This gives it enough torque to drill for even #9 pins in the laminated cap at a low enough speed to not smoke the hole. I like it a whole lot. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC