On 9/30/2011 12:33 PM, Encore Pianos wrote: > To those of you on the forum who do bridge recapping and such, I pose > the following question: what do you consider to be an optimal RPM speed > for the bridge pin drill bit to be turning at? Beats me. I built this little bridge drill with the B&D motor because it had the highest rated amperage I could find. This gives it enough torque to drill for even #9 pins in the laminated cap at a low enough speed to not smoke the hole. I like it a whole lot. Ron N -------------- next part -------------- A non-text attachment was scrubbed... Name: bridge drill2.jpg Type: image/jpeg Size: 83681 bytes Desc: not available URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20110930/69126b4f/attachment-0001.jpg>
This PTG archive page provided courtesy of Moy Piano Service, LLC