[pianotech] S&S K(52) Restoration

[Gene Nelson]

OR, ream the tuning pin holes in the plate and install (gasp!!) the narrow
tuning pin bushings.

Will Truitt


And ream the plate to get some clearance to keep the tuning pins off of the
hole edge.
Ron N

I like this idea - the plan is to drill the new block with plate installed
because I will only rout out the existing block - not completely remove and
replace - (never did this before) so to ream the plate to the size of the
tuning pin bushing sounds like it can only help with guiding the drill bit.
Gene