[pianotech] S&S K(52) Restoration

[Ron Nossaman]

On 6/8/2012 1:16 PM, Gene Nelson wrote:

> I like this idea - the plan is to drill the new block with plate installed
> because I will only rout out the existing block - not completely remove and
> replace - (never did this before) so to ream the plate to the size of the
> tuning pin bushing sounds like it can only help with guiding the drill bit.

The drill guide provided by bushings is a distant secondary level 
consideration. Getting the pin off the plate, and with the addition of 
bushings, pin support, are the primary.
Ron N