Thanks for that suggestion Joe. I wish my cellphone camera had worked; the little aliminum collar looked so good! I might get some 1/8" dowel, as you suggest, nice idea. But even if I had had it today, I suppose i'd have had to drill a pilot hole in it, and I didn't have any fine drill bits with me (or, indeed, a drill!). The simpler option would ha vebeen to fit a new hammer butt, and I am going to order some this week so as not to be caught out again. There was also a split wippen flange, but I had suitable flanges with me. Best regards, David. > David, > I've had a few customers like that. <G> That's really neat, imo. > However, the next time you run into that situation, you might consider > just drilling an 1/8" hole across the butt, slightly below the surface, at > the plate screw site and insert a piece of 1/8" dowel with Titebond III. > This will give you cross grain to anchor the screw into. (sounds more > complicated than it actually is.<G>) > Regards, > Joe -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20120529/7e0231cf/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC