Kent, It needn't be an advert for Cybertuner because you can do the same thing on TuneLab! Greg Newell Kent Swafford wrote: > Avery Todd wrote: > > >How does one determine which note to use > >as the pitch standard if one wants to let it float? > > My reply is going to sound like an ad for CyberTuner. When I get to a > piano that I tune regularly I use the pitch raise mode to accurately > measure the pitch level of the instrument. In pitch raise mode RCT > automatically measures the pitch level and stores the data of each note. > I start at A0 and play the note long enough for RCT to do the > measurement, then hit octave up and measure all the A's of the piano, > then do the same for all the C's. Then I go through slowly and look at > the measurements and determine the average pitch level. I am convinced > that this procedure has increased the stability of my tunings, because I > am _tuning_ pianos and not fighting with them over pitch level. This is > especially valuable with D's, who generally do not appreciated having > their pitch changed. If I really must change the pitch level of a D, I do > the correction pass, and then may measure to see at what pitch level the > piano really landed and tune it there. Saves some grief, and yields good > stability. > > Kent Swafford
This PTG archive page provided courtesy of Moy Piano Service, LLC