Sharp key height

[Newton Hunt]

And dip and jack position (both ways) and springs.  Then do it again and
evaluate.  DO it again and evaluate.  NOW you know what dip must be and
what hammer height must be.

Good action person, Master Later.

		Newton

A440A@aol.com wrote:
> 
> John writes:
> 
> <<What height do folks  prefer on sharps? Although I've seen 1/2" is
> common, this feels just a bit too high for my liking.>>
> 
>  Greetings,
>    I think 1/2" is the max.  but I don't set the heights on the sharps
> without first determining the blow distance and let-off........
> Ed