S & S 'D' Problems

[Avery Todd]

>Avery,
>It sounds as though the dealer tech lowered the stack rather than raised it.

No, it was definitely raised by 1/8-3/16". I talked to him this 
morning. He raised it by adding wood to the back rail where it 
contacts the keybed.

>Here's one thing you can check.  With the stack attached, measure 
>the height of
>the center of the hammer flange center pin from your bench. It should be 5
>3/4", or very close to it.

I have, and that's the measurement I got.

>Also the height of the center of the wippen flange
>center pin from the bench top should be 3 1/4".  This will give a differential
>of 2 1/2" (difference between the two heights).

Oops. I forgot to do this. Will try and do it later.

Avery