Re-pinning question

[Roger Jolly]

>
>I am of the opinion that one should ream the hole first.  NOT to make it
>bigger, but simply to remove that shoulder and make the hole round again.
>The problem is, I have not found one reamer that's right for the job.  The
>ones that are out there that I have found just make bad matters worse
>because they are made wrong in the first place.  If I live long enough, I'm
>going to design one that works.

Hi Jim,
            We use a drill bit in a T wrench for reaming and get very even 
results. You need a good pair of gloves, or you end up with some blisters 
in the palm of your hand,
A good post with a good over view.
Regards Roger