black rubber shoes

[Ed Sutton]

Michelle and Jeff-

Cut a scrap of buckskin into a 1" square, or a tad larger, then cut the square to
look like a "German battle cross."

Put some glue on it, then use the rod or the butt end of a drill bit to push it
into the cup on the back of the pedal, then trim the top edges flush while the rod
or bit is in place.

Life expectancy 100+ years.

Ed Sutton


----- Original Message -----
From: "michelle stranges" <stranges@Oswego.EDU>
To: "caut list" <caut@ptg.org>
Sent: Tuesday, January 13, 2004 3:20 PM
Subject: black rubber shoes


> OK-
>
> I call the rubber "end caps" on the bottom of the pedal rods going into the
> pedal itself (of Steinway grands) "shoes".
>
> Is Steinway the only place to get these "shoes"?
>
> I don't see them in Schaff and Pianotek does not carry them.
>
> Anyone know a sneaky (un-squeaky) source??
>
> :B
> Michelle
> (in 800 degrees below zero wind chill factor, Oswego NY)
>  YOU NEVER SAID NOTHIN' ABOUT THIS KUPELIAN!!!!!!!!!!!!!
> (I could use some of them shoes getting around campus.)
>
>
> _______________________________________________
> caut list info: https://www.moypiano.com/resources/#archives
>